Filter
Top Products
Configuring the System
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
10-5
Create the Operating Configuration
To maintain EMC compliance in NonStop S-series systems, Ethernet cables must
be equipped with a ferrite suppression component. Install the Ethernet cables that
connect the PMF CRUs to the Ethernet switches or hubs with the ferrite end of the
cables connected to the PMF CRUs.
a. At Switch 1, disconnect the cable attached to the Ethernet port on the PMF
CRU in slot 55, group 01.
b. Reconnect this end of the cable to any port on Switch 2 except the cascade
port. Insert the RJ-45 plug on the cable into the RJ-45 jack on the Ethernet
switch or hub until the tab on the plug clicks into place as shown in
Figure 10-3.
Figure 10-3. Connections for the Operating Configuration
VST535.vsd
Note: Connections vary
depending on the
Ethernet switch you use
Ethernet Switch 1
Ethernet Switch 2
To Primary
System
Console
To Backup
System
Console
Cascade
Port
Cascade
Port
Medium-Dependent
Interface (MDI) Switch
(Setting for Ethernet Switch)
MDI
To
Ethernet
Switch
To PC
MDI-X
Group 01 Processor Enclosure
PMF CRU Containing
Processor 0
Slot 50
PMF CRU Containing
Processor 1
Slot 55