Filter
Top Products
Troubleshooting
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
D-21
Dumping Processor Memory to Tape Offline
7. In the Processor Status dialog box:
a. When all processors are halted, select the processor you want to dump to
tape.
b. In the Processor Actions field, scroll to Tape Dump.
c. Click Perform action. The Dump Processor-n to Tape dialog box appears,
where n is the processor number of the selected processor.
8. In the Dump Processor-n to Tape dialog box:
a. Specify the location of the PMF CRU to which the tape drive is connected.
Tape drives connected to processor 0 or processor 1 are connect to SCSI
controllers on PMF CRUs. Each PMF CRU is associated with a ServerNet
fabric (X or Y). For example, you might select the PMF CRU in group 01,
module 01, slot 55, ServerNet Y fabric.
b. Specify the small computer system interface (SCSI) ID of the tape drive. The
default value is 5, the current software requirement.
c. Click Dump.
9. Monitor the tape dump. Status messages in the Processor Status dialog box
indicate the progress of the tape dump.
10. After the dump finishes successfully, start the system using the OSM or TSM
Low-Level Link.
11. Log off the OSM or TSM Low-Level Link.
Note. You can dump only to a tape drive that is connected to processor 0 or 1.