Filter
Top Products
FastPath Tasks: Required
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
E-25
3. Connect AC Power Cords
Enclosures With Power Shelves
For these enclosures, the DC power cords are shipped already connected to the power
shelves. Use the following procedure only if these cables are not connected:
1. Find the detachable AC power cords included with your system.
2. Start with the group 01 processor enclosure.
3. Select either of the power supplies. Orient the molded end of the AC power cord
with the single contact on the bottom. Insert the plug into the retainer until it is fully
seated:
4. Swing the locking bar down until it engages one of the slots on the plug housing
and snaps into place.
5. Repeat Steps 3 and 4 for the remaining power cord for this enclosure and for all
remaining enclosures that have power shelves.
Caution. Do not plug the other end of the AC power cord into the dedicated outlet at this time.
Doing so immediately powers on the PMF CRU or IOMF CRU.
WARNING. The underside of the locking bar is sharp. Placing your fingers under the locking
bar can result in injury. Failure to fully seat the plug in the retainer can result in cord damage
from the locking bar.
Power Cord
Retainer
VST983.vsd
AC Power Cord
Locking
Bar
Slots on
Plug Housing
01