Filter
Top Products
Performing Post-Startup Tasks
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
9-13
System Configuration Changes and Verifications
System Configuration Changes and Verifications
Table 9-1. System Configuration Changes and Verifications (page 1 of 2)
Change or Verification Required Recommended
Optional or
As Needed
Configure Kernel-Managed Swap Facility
(KMSF) files. See the Kernel-Managed Swap
Facility (KMSF) Manual.
X
Change the system name and system number
attributes. See Changing System Name,
System Number, or Time Attributes on
page 11-3.
X
Check and set the system time. See the SCF
Reference Manual for the Kernel Subsystem.
X
Configure DSM/SCM. See the DSM/SCM
User’s Guide. Some DSM/SCM configuration
is required as a result of changing the system
name.
XX
Verify that all updatable firmware is at the
proper revision level, using the OSM Service
Connection or TSM Service Application. See
the OSM User’s Guide, the TSM Online User
Guide, or the G06.nn Software Installation and
Upgrade Guide.
X
Verify the SP firmware, using the OSM Service
Connection or TSM Service Application. See
the OSM User’s Guide, the TSM Online User
Guide, or the G06.nn Software Installation and
Upgrade Guide.
X
With SCF, verify that paths and connections
within the ServerNet system area network are
properly configured and functional. See the
NonStop S-Series Operations Guide.
X
Configure low-level link user names and
passwords. See the TSM Configuration Guide
or the OSM Low-Level Link online help.
Service connection user names and
passwords are created when you add
NonStop user names and passwords.
X
Configure a backup system console. See
Section 10, Configuring the System
.
X
Invoke the STARTCOM and STARTSCF
startup files to configure standard TCP/IP
objects and start TCP/IP services. See
4e. Invoke STARTCOM and STARTSCF
Startup Files on page E-40.
X