Filter
Top Products
SRPL8 Server System Product Guide 103
Installing the LCD Module
See Figure 27.
1. Connect the LCD module data and power cables to the front panel board. To attach the data
cable, insert the connector end of the cable into the connector on the front panel board. This
action causes the two levers on the board connector to close slightly. When that happens, push
the levers together until the cable connector is fully seated in the board connector.
✏
NOTE
Verify that both cables are below the sheet of insulating material above the
front panel board.
2. Insert the tab on the left side of the LCD module into the slot and insert the screw on the right
side of the module that you removed earlier and tighten it firmly (8.0 inch-pounds).
3. Install the fan array housing.
4. Install the memory module cover.
OM10704
A
B
Figure 27. Removing the LCD Module
A. Memory module cover
B. LCD module