Filter
Top Products
SRPL8 Server System Product Guide 115
Installing the I/O Tray
See Figure 34.
1. Position the tray over the chassis and lower it onto its supports.
2. Ensure that the midplane and I/O carrier tray connectors are properly aligned.
3. Simultaneously rotate the eject/insert levers into the locked position. This action also mates
the PHP I/O carrier connector with the midplane connector.
4. Use the screws you removed earlier to secure the I/O tray to the chassis.
5. Connect all internal cables to the PHP I/O carrier.
6. Install all add-in boards (see “Add-In Boards” on page 108).
7. Connect all peripheral device cables connected to the I/O panel on the back of the system.
8. Install the top and 240 VA protective covers (see “Installing the Top Cover” on page 99).
OM10653
A
A
B
B
C
A
Figure 34. Removing the I/O Tray
A. Screws (four)
B. Eject/insert levers
C. I/O tray