SRPL8 Server System Product Guide 109
OM08752
D
C
B
A
Figure 30. Enhanced PHP Functionality on Add-in Board Slots
A. PHP LED board
B. EPHP mechanism
C. EPHP actuator
D. EPHP mechanism, open position
3. Being careful not to touch the components or gold edge connectors on the add-in board,
remove it from the protective wrapper, and place it component-side up on a nonconductive,
antistatic surface.
4. Record the serial number of the board in your equipment log (see page 197).
5. Set any jumpers or switches according to the board manufacturer’s instructions.
6. If your server is not operating, skip this step. If your server is operating:
• Access the PCI hot-plug utility on the CD-ROM that came with your server.
• Use the PCI hot-plug utility to power down the appropriate PCI slot.
7. Press the EPHP mechanism on the actuator (C), then rotate the mechanism to free the PCI
board from its connector.
8. Remove the I/O slot filler panel for the appropriate slot.
9. Grasp the board by the top edge or upper corners, and firmly press it into an expansion slot
on
the PHP I/O carrier (see Figure 31). The tapered foot of the processor retaining bracket must
fit into the mating slot in the expansion slot frame.
10. Secure the add-in board to the expansion slot frame using the power enabling switch actuator
(rotate the EPHP mechanism back into place) and expansion slot cover retaining screw.
11. Connect any required cabling to the add-in board.
12. If your server is not operating, skip this step. If your server is operating:
• Use the PCI hot-plug utility to power up the PCI slot.
13. Reinstall the top and cover (see “Installing the Top Cover” on page 99).
14. Running the SSU is optional for a PCI add-in board. For information about running this
utility, see “Using the System Setup Utility (SSU) ” on page 51.