SRPL8 Server System Product Guide 151
Installing a Termination Board
See Figure 53.
1. Grasp the terminator board by the eject/insert levers, (A) and carefully slide it into the slot
guides of the processor retention bracket until the board stops.
2. To seat the board in the mezzanine board connector, push down on the levers simultaneously,
making sure that the lever locks (B) engage with the slots of the processor retention bracket
flange (C).
3. Insert the hook end of the holddown bracket in the flange of the processor retention bracket.
4. Insert the screws you removed earlier and tighten them firmly (8.0 inch-pounds).
5. Install the top cover.
OM10694
A
B
C
Figure 53. Installing a Termination Board Assembly
A. Eject/insert levers
B. Lever locks
C. Slot in processor retention bracket
flange