Filter
Top Products
93
5 Working Inside the System
This chapter describes procedures for removing and installing most components inside the system.
Table 14 lists these procedures and their page numbers in this chapter.
Table 14. Procedures in Chapter 5
Item Page Item Page
• Front bezels 95 • I/O tray 113
• Server covers 95 • ICMB board 116
• Fan array housing 101 • AC filter and cable 117
• LCD module 102 • Peripheral bay 117
• Profusion carrier tray 104 • Peripheral bay backplane 119
• Front panel controller board 106 • Peripheral bay blind mate board 121
• Add-in boards 108 • Diskette drive 124
• I/O riser board 111 • Peripheral drives 126
• PHP LED Board 113
Tools and Supplies Needed
• Phillips (cross-head) screwdriver (#1 and #2 bit).
• Small flat-bladed screwdriver.
• Jumper removal tool or needle-nosed pliers.
• Antistatic wrist strap and conductive foam pad (recommended).
• Pen or pencil.
• Equipment log: as you integrate new parts into the system, add information about them to
your equipment log (page 197). Record the model and serial number of the system, all
installed options, and any other pertinent information specific to the system. You will need
this information when running the SSU.
Safety: Before You Remove Server Covers
Before removing covers at any time to work inside the system, observe these safety guidelines.
1. Turn off all peripheral devices connected to the system.
2. Turn off the system by using the push-button on/off power switch on the front of the system.
3. Unplug the AC power cords from the system or wall outlet.
4. Label and disconnect all peripheral cables and all telecommunication lines connected to
I/O connectors or ports on the back of the system.
5. Provide some electrostatic discharge (ESD) protection by wearing an antistatic wrist strap
attached to chassis ground of the system—any unpainted metal surface—when handling
components.