Filter
Top Products
SRPL8 Server System Product Guide 73
When to Run the FRUSDR Load Utility
You should run the FRUSDR load utility each time you upgrade or replace the hardware in your
server, excluding add-in boards, hard drives, and RAM.
Because the utility must be reloaded to properly initialize the sensors after programming, turn the
server off and remove the AC power cords from the server. Wait approximately 30 seconds, then
reconnect the power cords and turn on the server.
What You Need to Do
You can run the utility directly from the configuration software CD-ROM or from diskettes you
create from the CD-ROM.
If you choose to run the FRUSDR Load Utility from a diskette, you must copy the utility from the
CD-ROM and follow the instructions in the included README.TXT file.
If your diskette drive is disabled, or improperly configured, you must use BIOS Setup to enable it.
If necessary, you can disable the drive after you have finished using the FRUSDR utility.
How You Use the FRUSDR Load Utility
The utility:
• Is compatible with ROM-DOS Ver. 6.22, MS-DOS Ver. 6.22, and later versions.
• Accepts CFG, SDR, and FRU load files (the executable file for the utility is frusdr.exe).
• Requires the following supporting files:
One or more .fru files describing the system’s FRUs
A .cfg file describing the system configuration
An .sdr file describing the sensors in the system
Command Line Format
The basic command line format is
frusdr [-?] [-h] [-d {dmi, fru, sdr}] [-cfg filename.cfg] [-fru filename.fru]
Table 12. Command Line Format
Command Description
Frusdr Is the name of the utility.
-? or –h Displays usage information.
-d {dmi, fru, sdr} Displays requested area only.
-cfg filename.cfg Uses custom CFG file.
-p Pause between blocks of data.