Interphase Tech 5536 Network Card User Manual


 
Chapter 6: Setting Up Calls
5536 PRI RAS Communications Controller Users Guide 93
The Remote Access Setup dialog box reappears.
8. To quickly add and configure remaining channels as
RAS ports with the same properties as a configured
port, do the following:
a. Select the port whose properties you want to copy,
and click the Clone button.
The next available channel is added to the port list.
The port usage properties are copied from the
selected port.
b. Click the Clone button repeatedly until you have
configured all the RAS ports you need.
Or to configure the channels’ port usage properties one-
by-one, click Add to display the Add RAS Device
dialog box. Then repeat Steps 5 through 7.
9. When you have finished configuring RAS ports, on the
Remote Access Setup dialog box, click Continue.
The Network Services dialog box reappears.
10. To make the settings take effect, click Close.
A message informs you that you must shut down and
restart your computer before the settings take effect.
11. Continue as follows:
If the system is a basic Windows NT system, without
the Windows NT Service Pack installed, click Yes to
restart the computer.
If the Windows NT Service Pack is installed, click
No. Then reinstall the Service Pack. (Service Pack 3
or higher is recommended.) Restart the system when
prompted after you complete the Service Pack
installation.