![](http://pdfasset.owneriq.net/3/eb/3eb3d6c4-f8a4-43e0-b0c0-a925198b1757/3eb3d6c4-f8a4-43e0-b0c0-a925198b1757-bgb2.png)
Understanding LoopTest Messages
158 Interphase Corporation
Understanding LoopTest Messages
The Diagnostic field in the main LoopTest dialog displays
LoopTest test results:
Figure C-3. LoopTest Test Results
The following table describes diagnostic messages:
Message Cause
Test passed LoopTest detected no errors during testing.
Card missing or
non-ISDN
An error occurred before accessing the network.
Possible causes are:
• The card is not installed.
• The drivers are not properly installed.
• LoopTest could not find an ISDN port on the card.
To check for ISDN ports:
a. From the Start menu, select Programs, then
Interphase WAN Adapters, and then WAN
Setup.
b. Make sure the firmware contains the ISDN layer.