Interphase Tech 5536 Network Card User Manual


 
Chapter 7: Managing Serial Driver COM Ports
5536 PRI RAS Communications Controller Users Guide 111
4. When you are prompted to choose a port on which to
run detection, select the port where you want to declare
a modem.
Serial driver COM ports are named COM
ixx, where i is
the card number and xx is the port number. Card
numbers start with 0; port numbers start with 01.
To be available, Serial driver COM ports must be
assigned to the board. By default, eight Serial driver
COM ports (COM
i01COMi08) are assigned to each
5536-DM WAN board. (You can change COM port
assignments using the WAN Adapters Setup utility. For
information, see Setting Up Card Properties on page
77.)
5. Click Next.
A message asks you to wait while Windows NT
attempts to detect your modem.
6. If a modem is not detected, and you are prompted to
select your modem from a list, do the following:
a. Click Next to display a list of modem manufacturers
and models.
b. Select Interphase in the Manufacturers list, and
select Interphase Digital Modem in the Models
list. Then click Next.
7. When you are asked on which port to install the modem,
select this or any other digital modem port(s) to be used
as the serial modem port(s). Then click Next.
8. When you are informed that you will need to restart the
system before you can use the modem on the ports, click
OK to continue.