Interphase Tech 5536 Network Card User Manual


 
Hardware Management
76 Interphase Corporation
Hardware Management
The Cards section of the WAN Adapters Setup dialog box
displays all the 5536 WAN boards installed in the machine,
their status, and their available communication ports. The
Firmware section displays information about the board
selected in the Cards section. You can use the buttons in the
Cards section to add, remove, or configure WAN boards.
NOTE
If you change any firmware, card, or port properties, you
must apply changes, reload the firmware, save properties,
and restart the system, as described in Saving WAN Setup
Properties on page 87.
The board status is represented by its icon color:
Use the following buttons to set up board hardware:
LED Color Meaning
Gray The board is detected but is not working.
Yellow The hardware configuration has been changed but not
applied.
Green The board is running.
Click... To do this...
Add Add a new board to the operating system. This option is
enabled if one or more Interphase WAN cards can be
installed.
Remove Remove an 5536 board. This option removes the board and
its drivers from the operating system.