Interphase Tech 5536 Network Card User Manual


 
Appendix F: Quick Reference of Common Tasks
5536 PRI RAS Communications Controller Users Guide 181
Open the Remote
Access Setup dialog
box
1. From the Start menu, select Settings, and then
Control Panel.
2. Double-click the Network icon, and select the
Services tab to display the Services dialog box:
3. From the Network Services list, select Remote
Access Service, and then click Properties.
Figure F-2. Remote Access Setup
Bind a protocol to
an ISDN or Digital
Modem RAS Port
1. Open the Remote Access Setup dialog box. (See
Open the Remote Access Setup dialog box.) Then
click Network.
NetBEUI, IPX/SPX, and TCP/IP protocols are
available. RAS allows you to configure them
differently depending on the connection type: dial-
in or dial-out.
2. Select the protocol(s) you want to bind to the
board.
NOTE: The more protocols you bind, the more
memory RAS uses.
Configure a RAS
port to accept
incoming calls
1. Open the Remote Access Setup dialog box. (See
Open the Remote Access Setup dialog box.) Then
select the port and click Configure.
2. Select either the Receive calls only or the Dial out
and Receive calls option, and click OK.
If you want to... Do this...