Interphase Tech 5536 Network Card User Manual


 
Chapter 3: Connecting to the Line
5536 PRI RAS Communications Controller Users Guide 35
Connecting to the Network
WARNING
Before connecting the cable, read Telephone Lines
Unsafe Voltages in the Safety Precautions section at the
front of this manual.
With the board installed, you are ready to connect to the
network, as follows:
1. Obtain the cable required for your type of connection, as
described in T1 Link Requirements on page 31 or
E1/PRI Cabling Requirements on page 32.
2. Attach the appropriate RJ48C-compliant connector to
the board.
3. Reconnect the power cable and turn on the machine.
After connecting to the network, install the drivers. See
Installing the Software on page 37.