Interphase Tech 5536 Network Card User Manual


 
4
5536 PRI RAS Communications Controller Users Guide 37
4Installing the
Software
Overview
This chapter describes the procedures for installing and setting
up your 5536 software on Microsoft Windows NT 4.0
workstations. Use this process to install the Base driver (along
with the Serial driver and utilities), the ISDN RAS support
driver, the Digital Modem RAS support driver, the SecurID
support driver and service, and the Acotec Virtual Motion
Remote Access Manager Suite. This chapter also explains how
to remove 5536 software, if required.
To install and set up the software, follow these basic steps:
1. Verify that your system meets minimum requirements.
2. Install the Base driver, with accompanying software,
and the appropriate RAS support driver(s).
3. Set up WAN card and port properties.
4. Set up RAS support properties for the installed RAS
driver(s).
5. Set up ISDN B and Digital Modem channels as RAS
ports.
6. If you want to use Acotec Virtual Motion RAS
management services on the computer, install Remote
Access Manager Suite components.
7. Complete the installation to make driver settings take
effect.