Konica Minolta 7013 All in One Printer User Manual


 
7
Gently clean the LED print head
using the cleaning paper included in
the toner cartridge carton box.
For best print quality, you should
clean the LED head every time you
change the new toner cartridge.
Note: Do not use abrasive materials
on the LED print head, and
do not subject the LED print
head to strongly shock.
8
Gently close the printer cover.
9
Close the top cover. Be sure to push on a portion of the cover to lock it into its
original (closed) position.
Note: The fax machine will not work if the cover isn’t closed properly.
Attach the extension paper tray
Attach the extension paper tray by inserting its two pegs at a slightly upward angle
into the appropriate holes, as shown.
Plug in and power up
1
Plug one end of the telephone line cord into the
LINE
jack on the machine’s
rear side and the other end into a standard telephone wall jack.
2
Plug the non-pronged end of the AC power cord into the AC power cord jack
on the right rear side of the machine and the pronged end into a 230 V electri-
cal outlet (preferably on a surge suppressor, as mentioned on page 1.5).
Important: Be sure that you do not turn the power on (next step) until after
you have unlocked the mirror carriage locking plate. (see page
1.5).
3
Use the AC power switch to turn on your machine. The markings are interna-
tional standards: I means on, O means off.
It will take a few seconds for the machine to warm up. The
LCD
shows:
When the machine is ready to use (standby mode), you will see:
Copy Ready 1
A4 Auto 100%
** Warming Up **
1.7
Getting started