Filter
Top Products
x
Installation Precautions
Environment
CAUTION
• Avoid placing the printer on or in locations which are unstable or not level. Such locations may
cause the printer to fall down or fall over. This type of situation presents a danger of personal
injury or damage to the printer. .......................................................................................
• Avoid locations with humidity or dust and dirt. If dust or dirt becomes attached to the power
plug, clean the plug to avoid the danger of fire or electrical shock. ......................................
• Avoid locations near radiators, heaters, or other heat sources, or locations near flammable
items, to avoid the danger of fire. ....................................................................................
• To keep the printer cool and facilitate changing of parts and maintenance, allow access space
as shown below. Leave adequate space, especially around the side cover, to allow air to be
properly ventilated out of the printer. ...............................................................................
Other Precautions
• Adverse environmental conditions may affect the safe operation and performance of the
printer. Install in an air-conditioned room (recommended room temperature: around 20 °C,
humidity: around 65 % RH) and avoid the following locations when selecting a site for the
printer.
• Avoid locations near a window or with exposure to direct sunlight.
• Avoid locations with vibrations.
• Avoid locations with drastic temperature fluctuations.
• Avoid locations with direct exposure to hot or cold air.
• Avoid poorly ventilated locations.
• If the floor is delicate against casters, when this product is moved after installation, the floor
material may be damaged.
Left: 40 cm
(15-3/4 inches)
Right: 25 cm
(10 inches)
Rear: 25 cm
(10 inches)
([40 cm (15-3/4 inches)
when the optional face-up
output tray is installed]
Front: 60 cm
(23-5/8 inches)
Top: 75 cm
(29-1/2 inches)