Filter
Top Products
A.2 Expansion Memory Modules
A-6
Removing a Memory Module
To remove a memory module, remove the main controller board, then carefully push out the
two socket clamps. Ease the memory module out of the socket to remove.
Testing the expanded memory
To verify that the memory modules are working properly, test them by printing a status
page. To print a status page:
1
Make sure the printer is switched off. Plug in the printer power cord into an AC
outlet and power on the printer.
2
Wait until the printer becomes Ready. When ready, press the MENU key.
3
Press the V key repeatedly until the message display shows Print Status
Page.
4
Press the ENTER key twice. A status page is printed.
Check the Memory field in the upper right area. It shows information about the memory
modules installed in memory slots 1 and 2. If you see an increase in the total memory size,
the installation is successful. (Note that the printer is shipped with 128 MB of base
memory.)