Filter
Top Products
3.4 e-MPS
3-30
3.4.5 Changing e-MPS Configuration
You can change the following parameters for e-MPS operation:
• Maximum number of Quick Copy/Proof-and-Hold jobs
• Maximum space assigned to temporary code jobs
• Maximum space assigned to permanent code jobs
• Maximum space assigned to virtual mailboxes
Changing the Maximum Number of Quick Copy/Proof-and-Hold Jobs
This changes maximum number of Quick Copy/Proof-and-Hold jobs from 0 to 50. The
default is 32.
1
Press the MENU key.
2
Press the U or V key repeatedly until e-MPS > appears.
3
Press the Z key.
4
Press the U or V key repeatedly until >e-MPS Configuration > appears.
5
Press the Z key.
6
Press the U or V key repeatedly until >>Quick Copy appears.
7
Press the ENTER key. A blinking cursor (_) appears.
8
Press the U or V key to increase or decrease the value at the blinking cursor. The
value can be set between 0 and 50. Use the Z and Y keys to move the cursor right
and left.
9
When the desired maximum number of jobs is set, press the ENTER key.
The total amount of storage areas specified must not exceed the total size of
the hard disk. Otherwise, you may only be able to accommodate print jobs
of a smaller amount of print jobs than specified.
Note
e-MPS >
>e-MPS >
Configuration
>>Quick Copy
32
>>Quick Copy
32