Filter
Top Products
3.4 e-MPS
3-24
3.4.3 Printing a Private Print/Stored Job
In private printing, you can specify that a job is not printed until you release the job from the
operator panel. At sending the job from the application software, you can specify a 4-digit
access code in the printer driver. The job is released for printing by entering the access code
on the operator panel. Thus, this function ensures confidentiality of the print job.
In the stored job mode, access codes are not mandatory, but can be set on the printer driver if
printing with the PIN security is required. Then, the access code must be entered on the
operator panel to print a stored job. Print data will be stored in the hard disk after printing.
See KX Printer Drivers Operation Guide for the driver settings.
Releasing a Private/Stored Job
1
Press the MENU key.
2
Press the U or V key repeatedly until e-MPS > appears.
3
Press the Z key.
4
Press the U or V key repeatedly until >Private/Stored appears. The name
entered in the printer driver (Harold, in this example) also appears.
5
Press the ENTER key. A blinking question mark (?) appears before the user name.
6
Press the U or V key to display the desired user name (Arlen, in this example).
7
Press the ENTER key. The user name and the job name (Agenda, in this example)
entered in the printer driver appear with a blinking question mark (?).
8
Press the U or V key to display the desired job title.
e-MPS >
>Private/Stored
Harold
>Private/Stored
?Harold
>Private/Stored
?Arlen
>Arlen
?Agenda