Lantronix SLSLP400PS201 Switch User Manual


 
3: Installing the Spider Device
Spider™ and SpiderDuo® KVM-over-IP Device User Guide 27
4. The Pwr2 LED illuminates blue and the SysOK LED flashes green to indicate that the Spider
device is booting. Bootup should complete within one minute. The SysOK LED stops flashing
and remains illuminated. If you use the external power supply to boot, Pwr1 illuminates blue.
lists the LED labels, colors, and actions.
5. When the bootup process completes, the terminal window displays the login prompt as shown
in Figure 3-3.
Figure 3-3 Spider Login Window
6. To change the default IP auto configuration from DHCP to a static IP address, type config
and press Enter.
7. At the IP autoconfiguration prompt, type none and press Enter.
8. Follow the prompts to enter the IP address, subnet mask, default gateway, and LAN interface
information as shown in Figure 3-4.
Figure 3-4 Spider Prompts
9. Type Y and press Enter to accept the changes. The system takes several seconds to update
the internal protocol stack and display the updated information. See Detector Installation and
IP Address Reset on page 28 for more information about using Detector.
10. Plug an Ethernet cable connected to your network into the Ethernet port. The Lnk LED in the
RJ45 illuminates. The RJ45 jack is shown in Figure 3-5.
Table 3-2 Spider LEDs
Label Color Action
Pwr1 Blue Indicates adequate power from USB1 (external power supply first).
Pwr2 Blue Indicates adequate power from USB2 or PS/2.
SysOK Green Blinks upon bootup. Steady when up and healthy.
Video Green Indicates that video (VSync) transmitting from server.
Unit ID Orange Indicates, when lit, to assist in finding unit.