Filter
Top Products
7: Interfaces
Spider™ and SpiderDuo® KVM-over-IP Device User Guide 58
Lan Interface Settings
IPv6 Settings (Firmware v3.0 or higher)
Miscellaneous Network Settings
Secondary DNS Server
IP Address (optional)
Enter the IP address of the Domain Name Server to be used if the Primary
DNS Server cannot be reached.
Field Description
Current LAN interface
parameters
Displays current LAN interface settings.
LAN interface speed Manual setup may be required for older equipment. With autonegotiation on,
the window displays the current state of the link. Note that the parameters of
the second Ethernet port are not configurable, they remain at autonegotiate.
Select the speed from the drop-down menu.
LAN interface duplex
mode
Select the duplex mode from the drop-down menu.
Field Description
Enable IPv6 Select to enable IPv6.
IPv6 address IPv6 address displays when enable IPv6 is selected,
IPv6 address dynamic Assigned automatically by the system.
Link-local IPv6 address Network address intended only for communications within one segment of a
local network or a point-to-point link. Assigned automatically by the system.
Field Description
Remote Console &
HTTPS port
Port number at which the Spider device Remote Console server and HTTPS
server are listening. The default is 443.
HTTP port Port number at which the Spider device’s HTTP server is listening. The
default is 80.
TELNET port Port number at which the Spider device’s Telnet server is listening. The
default is 23.
SSH port Port number at which the Spider device’s SSH server is listening. The
default is 22.
Bandwidth Limit The maximum network traffic generated through the Spider device’s primary
Ethernet port, in kilobits. If left blank, there is no bandwidth limitation applied.
Enable TELNET/SSH
access
For security, the default is having Telnet and SSH disabled. Check the
appropriate box (es) and set up the serial port for Telnet/SSH to use the
Telnet console.
Field Description