Spider™ and SpiderDuo® KVM-over-IP Device User Guide 3
Disclaimer and Revisions
Operation of this equipment in a residential area is likely to cause interference, in which case the
user, at his or her own expense, will be required to pay for to take whatever measures may be
required to correct the interference.
This equipment has been tested and found to comply with the limits for Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with this User Guide, may clause interference to radio communications.
Operation of this equipment in a residential area is likely to cause interference, in which case the
user will be required to correct the interference at his own expense.
The user is cautioned that changes and modifications made to the equipment without approval of
the manufacturer could void the user’s authority to operate this equipment.
Changes or modifications to this device not explicitly approved by Lantronix will voids the user's
authority to operate the device.
Documentation Changes
The information in this guide may change without notice. The manufacturer assumes no
responsibility for any errors that may appear in this guide. For the latest revision of product
documents, please check our online documentation at www.lantronix.com/support/documentation
.
Revision History
Date Rev. Comments
March 2007 A Initial Document
November 2007 B Changed baud rate default to 9600; added Detector utility for assigning IP
address; added ability to enable drive redirection, configure backup/restore,
and reset factory defaults; introduced a CLI and commands.
April 2008 C Added Direct KVM; KVM-only mode; Spider device network web page;
ability to preserve network settings for factory defaults; country code
support; iGoogle gadget; instructions for using the mounting kit.
May 2009 D Updated to firmware version 2.2, VIP access.
September 2009 E Updated and added SpiderDuo.
March 2010 F Updated to firmware version 3.01.
November 2013 G Updated product name and trademark information. Removed mention of
ManageLinx, VIP and DSM.