Filter
Top Products
Close flatbed cover and load originals if restarting job [2yy.xx]
Try one or more of the following:
• Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan
job.
• Touch Scan from flatbed to continue scanning from the scanner glass immediately after the last successful scan
job.
• Touch Finish job without further scanning to end the last successful scan job.
Note: This does not cancel the scan job. All successfully scanned pages will be processed further for copying,
faxing, or e-mailing.
• Touch Cancel job to clear the message and cancel the scan job.
[Color] cartridge low [88.xy]
You may need to order a toner cartridge. If necessary, touch Continue on the printer control panel to clear the message
and continue printing.
[Color] cartridge nearly low [88.xy]
If necessary, touch Continue on the printer control panel to clear the message and continue printing.
[Color] cartridge very low, [x] estimated pages remain [88.xy]
You may need to replace the toner cartridge very soon. For more information, see the “Replacing supplies” section of
the User’s Guide.
If necessary, touch Continue on the printer control panel to clear the message and continue printing.
Complex page, some data may not have printed [39]
Try one or more of the following:
• From the printer control panel, touch Continue to ignore the message and continue printing.
• Cancel current print job.
• Install additional printer memory.
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of the following possible changes in the printer:
• The printer firmware has been updated.
• The tray for the print job has been removed.
• The print job is sent from a flash drive that is no longer attached to the USB port.
• The printer hard disk contains print jobs that were stored when the hard disk was installed in a different printer
model.
From the printer control panel, touch Continue to clear the message.
Troubleshooting 261