Filter
Top Products
81
Loading paper
Setting Top-Of-Form
Top-Of-Form sets the first line of print. Use the operator
panel to save your Top-of-Form settings for continuous
forms, a cut form, and for each macro enabled.
Setting Top-Of-Form for continuous
form paper in push mode
Top-Of-Form can range from minus 1 inch to plus
14 inches from the top of continuous form paper.
Note:
Use this method to also set Top-Of-Form
for continuous forms loaded in the
optional Tractor 2 Feeder.
To set and save Top-Of-Form:
1
Clear the paper path.
The Paper Out light blinks if no paper is loaded.
If the Paper Out light is
Off
, tear off excess
forms and press
Load/Unload
.
If an individual form is loaded, press
FormFeed
to clear paper path.
2
Make sure the paper select lever is in the
continuous forms position.
3
Load continuous form paper on the push
tractor feed pins (or Tractor 2 feed pins if you
are using the optional Tractor 2 Feeder).
For help loading paper, see “Loading
continuous forms using the push tractor” on
page 48.
4
Remove the ribbon access cover.
5
Press
Load/Unload
.
The paper moves to the current Top-Of-Form.
The Paper Out light goes
Off
.