Magnetek Quattro DC Elevator Drive Computer Hardware User Manual


 
Quattro DC Introduction
Drive Model Numbers
The Quattro DC drive is currently available
with three different output currents and a
variety of options.
The enclosure options consist of a customer
I/O panel and a side Dynamic Braking Resistor
box. The Dynamic Braking Resistor box is an
optional box that is attached to the right hand
side of the cabinet. It is used to hold the
dynamic braking resistors. The customer I/O
panel is an optional larger width cabinet that
allows for customer interfacing within the
supplied cabinet. See Dimensions / Weights
on page 104.
The next option consists of shipping, either
domestically or internationally. Due to
international standards, the shipping crate
must be heat-treated.
The final option section determines the type of
motor contactor and Magnetek Operator. The
Magnetek Operator is not required to start
running, but allows for easy access to
parameters, overspeed test, and auto tuning.
options
00 = No operator, ABB type
Contactor
01 = Operator, ABB type
Contactor
02 = No Magnetek Operator,
Dual DC Contactor
03 = Operator, Dual DC
Contactor
enclosure options
1 = no customer I/O panel, no side DBR box
2 = no customer I/O panel, side DBR box
3 = customer I/O panel, no side DBR box
4 = customer I/O panel, side DBR box
output current rating
125 = 125A output current
200 = 200A output current
250 = 250A out
p
ut current
software program
QDC
- -
drive
1 0
shipping type
1 = domestic
2 = international
11