Filter
Top Products
113
Outputs
Output connector descriptions
This section describes the Matrox MXO2, MXO2 Rack, and MXO2 LE outputs.
For MXO2 Mini outputs, see “Output connector descriptions (MXO2 Mini)” on
page 115.
HD to SD downscaling, SD to HD upscaling, and cross conversion are supported
on all video outputs simultaneously. To select your video output settings, see
“Specifying your video output settings” on page 52. You can also map any audio
track in Final Cut Pro to any MXO2 audio output (see “Specifying your audio
output settings” on page 57). For a list of the video formats that you can output
from the MXO2 outputs, see “Video formats supported on MXO2 outputs” on
page 122.
¦NoteDepending on your MXO2 hardware, some of the following connectors
may not be available or may be available in a limited capacity only. Some
connectors on your MXO2 hardware may not appear exactly as shown below.
HDMI Provides an output for HD/SD HDMI video, and up to
eight channels of embedded audio, to a digital HDMI device.
HDCP is not supported on this output. This output supports 1:1
pixel mapping for accurate monitoring on your HDMI display
of NTSC, PAL, 1280×720, and 1920×1080 video. Connect a
standard HDMI video/audio cable to an HDMI monitor, VTR,
or other digital HDMI device. You can also connect directly to a
home theatre system for 5.1 surround sound monitoring.
¦NoteThe HDMI output supports YUV and RGB
devices. To set the HDMI output type, see “Specifying
your video output settings” on page 52.
HDMI monitor calibration is available through this output.
Using proc amp controls (hue, chroma, contrast, brightness, and
blue-only), you can calibrate your HDMI monitor as you would
a broadcast HD/SD video monitor (see Chapter 8, “Calibrating
Your HDMI Monitor for Video”).