Muratec F-120 Fax Machine User Manual


 
1.6
Getting started
Pick an installation spot before going ahead
Where should you install your fax machine? The location should be:
Clean — Dust buildup can damage your machine. (However, do not use a cover!
See next item.)
In the open — Allow at least 12of clearance around your machine. Be sure
that you never cover the machine: its vents must be able to “breathe.”
Away from direct sunlight — This helps avoid overheating.
Dry — Avoid any location where splatters or sprays (such as from a water foun-
tain) could reach your fax machine.
Level, and vibration-free.
Near a phone jack — Your fax machine uses a standard (“modular”) telephone
jack, also known as an RJ-11.
Near an
AC
power outlet — The
AC
power cord is about 5 long when stretched
to its limit (and that’s not the way to handle a power cord).
Speaking of which …
Please heed these power-ful tips
Use a standard three-pronged 120
VAC
outlet.
Make sure the outlet isn’t controlled by a wall switch.
If it is, you’ll risk inadvertent shutoffs of your machine, causing
you to lose fax messages.
Don’t use an outlet which also is supplying power to a
large appliance, such a refrigerator or air conditioner.
Such high-consumption appliances can cause “draw-downs”
(temporary drops in the power available for other equipment on
the circuit) which could damage your fax machine.
If at all possible, use an electrical surge suppressor, preferably one which
guards both telephone and electrical lines. This device helps to shield your fax
machine from damaging high-voltage electrical surges.
Voltage requirements: 120
VAC
± 10%, 50–60% Hz.
Power consumption: Standby Transmission Reception Copying Maximum*
F-150 15
W
41
W
379
W
374
W
396
W
F-120/F-100 14
W
37
W
373
W
372
W
396
W
* F-150 and F-120; simultaneous copying, communicating and scanning.
Install the printing supplies
Your fax machine prints incoming faxes and copies with a laser print engine. The
engine requires two types of printing supplies (sometimes also called consumables):
The drum cartridge — It yields 20,000 normal letter-sized printouts (see “Specifi-
cations,” page
AI
.1). By “normal,” we’re referring to the amount of text and/or
graphics on each page. This is based on an industry-standard test document.
The toner cartridge — It yields 5,500 such printouts (see “Specifications,” page
AI
.1).
Note: The toner cartridge included with your machine is a starter cartridge which
yields 3,600 printouts (see “Specifications,” page
AI
.1). Please purchase
regular, full-yield toner cartridges from your authorized Muratec dealer.
Here’s how to install these supplies.
1
Swing open the printer
cover by pressing the
printer cover release.
2
Unpack the drum cartridge from its box.
Important: Shield the drum cartridge from light, especially strong
light. Later, if you have to remove the cartridge from the fax,
immediately wrap it in a thick cloth to protect it from light.
3
Put the drum cartridge into the printer
by aligning the cartridge’s protrusions
with the slits inside the printer frame.
Important: You must also reset the
drum counter. See “When
you install a new drum
cartridge …” (page 1.7).
Setting up