Filter
Top Products
Configuration and Installation Chapter 2
Lab-NB User Manual 2-4 © National Instruments Corporation
W2
ABC
W1
Channel 1
Channel 0
ABC
Figure 2-2. Bipolar Output Jumper Configuration
Unipolar Output Selection
You can select the unipolar (0 to 10 V) output configuration for either analog output channel by
setting the following jumpers:
Analog Output Channel 0 W1 B-C
Analog Output Channel 1 W2 B-C
This configuration is shown in Figure 2-3.
W2
ABC
W1
Channel 1
Channel 0
ABC
Figure 2-3. Unipolar Output Jumper Configuration
Analog Input Configuration
Two ranges are available for the analog inputs: bipolar (±5 V) and unipolar (0 to 10 V). Jumper
W3 controls the input range for all eight analog input channels.
Bipolar Input Selection
You can select the bipolar (±5 V) input configuration by setting the following jumper:
Analog Input W3 A-B
This configuration is shown in Figure 2-4.