Filter
Top Products
Chapter 1 Getting Started with Your 653X
653X User Manual 1-6 ni.com
Remove the device from the package and inspect the device for loose
components or any sign of damage. Notify National Instruments if the
device appears damaged in any way. Do not install a damaged device into
your computer.
Store your 653X device in the antistatic envelope when not in use.
Installing Your 653X Device
The following are general installation instructions. Consult your computer
or chassis user manual or technical reference manual for specific
instructions and warnings about installing new devices.
Note
It is important to install the NI-DAQ driver software before installing your device(s)
to ensure the device(s) are properly detected.
Installing the PCI-DIO-32HS, PCI-6534, or PCI-7030/6533
You can install a PCI-DIO-32HS, PCI-6534, or PCI-7030/6533 device in
any available 5 V PCI expansion slot in your computer.
1. Turn off and unplug your computer.
2. Remove the cover.
3. Remove the expansion slot cover on the back panel of the computer.
4. Touch a metal part of your computer chassis to discharge any static
electricity that might be on your clothes or body.
5. Insert the 653X device into a 5 V PCI slot. It can be a tight fit, but do
not force the device into place.
6. Screw the mounting bracket of the 653X device to the back panel rail
of the computer.
7. Visually verify the installation. Make sure the device is not touching
other boards or components and is inserted fully in the slot.
8. Replace the cover of your computer.
9. Plug in and turn on your computer.
Now that your 653X device is installed, it is ready to be configured.