Filter
Top Products
System Configuration 2-7
Maxtor IDE Hard Drive Jumper Settings
The factory settings for the jumpers on the Maxtor IDE hard drive are shown in
the following table. The settings are for a single drive installed in the system.
Specifications for the hard drive are included in Section 9.
Maxtor IDE Hard Drive Jumper Settings
Function Jumper Pins Description
Master Device J50-1 and
J50-2
Sets hard drive as master device in single drive system.
Factory setting: pins J50-1 and J50-2 jumpered.
Slave Device J50-1 and
J50-2
Sets hard drive as slave.
Cable Select
(CSEL)
J48-1 and
J48-2
Not used. Factory setting: pins J48-1 and J48-2 open.
Cylinder
Limitation
J46-1 and
J46-2
Not used. Factory setting: pins J46-1 and J46-2 open.
Seagate IDE Hard Drive Jumper Settings
The factory settings for the jumpers on the Seagate IDE hard drive are shown in
the following table. The settings are for a single drive installed in the system.
Specifications for the hard drive are included in Section 9.
Seagate IDE Hard Drive Jumper Settings
Function Jumper Pins Description
Master Device 5 and 6 Sets hard drive as master device in single drive system.
Factory setting: pins 5 and 6 jumpered.
Slave Device Open Sets hard drive as slave.
Cable Select
(CSEL)
3 and 4 Not used. Factory setting: pins 3 and 4 open.
NEC 32X CD-ROM Drive Jumper Settings
The factory settings for the jumpers on the NEC 32X CD-ROM drive are shown
in the following table. The drive is set as the master device on the secondary
channel. Specifications for the CD-ROM drive are included in Section 9.
NEC 32X CD-ROM Drive Jumper Settings
Jumper Jumper Pin Settings
Cable Select (CS) Not used.
Slave Present (SL) Disabled, pin 2 open (factory default).
Enabled, pin 2 jumpered.
Master Select (MA) Enabled, pin 3 jumpered (factory default).
Disabled, pin 3 open.