Filter
Top Products
Disassembly and Reassembly 3-17
!
CAUTION
Using the wrong heat sink or no heat sink can damage the
processor, system board, or both. Ensure that the
replacement processor cartridge has the correct heat sink
(refer to the documentation that comes with the processor).
Do not use the heat sink from the removed processor
cartridge.
Additional installation information can be obtained from NEC
CSD (see Section 8, “NEC CSD Information Services” for
information on contacting NEC CSD).
2.
Align the replacement cartridge with the top of the retention mechanism so
that the notch in the cartridge connector aligns with the key in the Slot 1
connector.
3.
Insert the cartridge into the retention mechanism and evenly press down on
the cartridge until it is fully seated in the Slot 1 connector.
4.
Lock the cartridge in place by pressing out on the two locking levers.
Installing the Pentium II Processor Cartridge
A
– Locking Levers
D
– System Board
B
– Processor Cartridge
E
– Bottom Bar
C
– Retention Mechanism
F
– Top Bar