Filter
Top Products
System Board 4-7
8. Connect system power cables and external options.
9. Power on the system.
10. Run the BIOS Setup utility to check the configuration or to set a new
password (see Section 2).
Setting Wake-On LAN
Wake-On LAN jumper JWOL can be set to enable the onboard Wake-On LAN
function or to disable the function. Set jumper JWOL as follows.
!
CAUTION
Jumpers are set correctly at the factory for the system
configuration. Only change (or check) the appropriate
jumper setting for your application.
1. Power off and unplug the system and any peripherals.
!
WARNING
The system power must be off before removing the cover
and changing a jumper setting.
2. Remove the left side cover (see “Removing the Left Side Cover” in
Section 3).
3. Locate jumper JWOL on the system board.
4. Set jumper JWOL as follows.
Set the jumper on pins 1 and 2 to enable the Wake-On WAN function.
Set the jumper on pins 2 and 3 to disable the Wake-On WAN function.
5. Replace the left side cover (see “Replacing the Left Side Cover” in
Section 3).
6. Connect any peripherals and power cords and power up the system.
7. Press
F2
to open the BIOS Setup utility, navigate to Power Management
Setup, and enable the “Resume By Ring” function (see Section 2, “System
Configuration”).
8. Save and close the BIOS Setup utility.