Filter
Top Products
4-6 System Board
4. Set jumper JP1 as follows.
Set the jumper on pins 1 and 2 to allow system boot up when the power
button is pressed.
Remove the jumper from pins 1 and 2 for immediate system boot up
when the power cord is plugged into a power source. Park the jumper on
one pin to prevent loss.
5. Replace the left side cover (see “Replacing the Left Side Cover” in
Section 3).
6. Connect any peripherals and power cords and power up the system.
7. Press
F2
to open the BIOS Setup utility.
8. Set the BIOS for the power option you jumpered (see “Advanced Menu -
Power Management Setup” in this section).
Clearing the CMOS and Password
If the CMOS needs to be restored to its factory state or the password needs to be
cleared and reset, set jumper block JBAT1 as follows.
!
CAUTION
Jumpers are set correctly at the factory for the system
configuration. Only change (or check) the appropriate
jumper setting if you forgot your password or want to change
the password.
1. Access the BIOS Setup utility and record any customized settings. See
“BIOS Setup” in Section 2.
2. Power off and unplug the system and any peripherals.
!
WARNING
The system power must be off before removing the cover
and changing a jumper setting.
3. Remove the left side cover (see “Removing the Left Side Cover” in
Section 3).
4. Locate jumper block JBAT1 on the system board.
5. Move the jumper from pins 1 and 2 to pins 2 and 3 to clear the CMOS and
password settings.
6. Move the jumper back to pins 1 and 2.
7. Replace the left side cover (see Section 3, “Replacing the Left Side Cover”).