Filter
Top Products
System Board 4-5
Processor Jumper Settings
5. Replace the left side cover (see “Replacing the Left Side Cover” in
Section 3).
6. Connect system power cables and external options.
7. Power on the system and run the BIOS Setup utility to check the
configuration of the system.
Setting the Power On Mode
The system can be jumpered to start up in one of the following modes:
when the power button is pressed or
when the power cord is plugged in (“Immediate Boot Up”).
Set Power On Mode jumper JP1 as follows.
1. Power off and unplug the system and any peripherals.
!
WARNING
The system power must be off before removing the cover
and changing a jumper setting.
2. Remove the left side cover (see “Removing the Left Side Cover” in
Section 3).
3. Locate jumper block JP1 on the system board.
233 MHz/66 MHz
350 MHz/100 MHz
266 MHz/66 MHz
400 MHz/100 MHz
300 MHz/66 MHz
450 MHz/100 MHz
333 MHz/66 MHz
500 MHz/100 MHz
366 MHz/66 MHz
400 MHz/66 MHz
433 MHz/66 MHz