Filter
Top Products
System Configuration 2-15
Advanced Menu - Power Management Setup
Menu Item Settings (default is bold)
Suspend Time Out
(Minutes)
Disabled, 1, 2, 4, 8, 10, 20, 30, 40, 50, 60
Specifies the length of time of system inactivity while in Standby state
before entering Suspend power state.
Power Button
Function
Sleep/Suspend
Sleep/Suspend sets the power switch for Suspend (Sleep) mode. With
power on, pressing the switch once places the system in sleep mode.
Pressing and holding the switch in for 4 seconds turns power off.
Restore on
AC/Power Loss
Stay Off, Power On, Last State
The Power On setting turns power on after a power loss. Jumper JP1
must be set for Power On (see “Setting System Board Jumpers” for
procedures on setting JP1).
Ring Resume from
Soft Off
Disabled, Enabled
The Disabled setting causes the system to ignore any incoming call
from a modem. Enabled allows the system to boot up on an incoming
telephone call. Not supported on Windows 98 systems.
LAN Resume from
Soft Off
Disabled, Enabled
The Disabled setting causes the system to ignore any incoming signal
from the LAN network board. Enabled allows the system to boot up on
an incoming LAN signal from the network board.
RTC Alarm
Resume from Soft
Off
Disabled, Enabled
When Enabled, you can choose the date and time the system boots up
(see the following date and time settings).
RTC Alarm Date Sets the day that the system boots up (RTC Alarm Resume Enabled).
RTC Alarm Hour Sets real time clock alarm hour (RTC Alarm Resume Enabled).
RTC Alarm Minute Sets real time clock alarm minute (RTC Alarm Resume Enabled).
RTC Alarm Second Sets real time clock alarm second (RTC Alarm Resume Enabled).