Filter
Top Products
Confi
g
urin
g
the Printe
r
3.2.1
Explanation of the Printout on the Previous Pages
In the headline behind the term
VER2
the revision level of the printer's firmware can be
found.
Then followin
g
the Printer Identification and in the next line a needle test.
The next part of the printout is a list of the
MACRO
settings.
In this case
MACRO 1
is marked with an asterisk (*) which identifies it as the active
macro.
N
o
te:
A “Macro“ is a summary of application specific parameter settings for a user. It is
possible to have a total of three macros, each with a different summary of VALUE
settin
g
s for different a
pp
lications.
Whenever you make modifications in the active macro without saving them you will find
the new settings under the heading
CURRENT USER
. Unless they are saved, the
modifications will stay active only until the printer is switched off. When the printer is
switched on a
g
ain the macro settin
g
s marked with the asterisk will be reactivated.
Note:
The
CURRENT USE
R
will be selected b
y
MACRO 1, MACRO 2, or MACRO 3.
3.3
Menu Structure
Press
[STATION 2]
and
[COMPRESS
–
] together to start the Menu-Mode in Off-line
operation.
The Menu Mode starts with
MENU SETUP
in level 1.
3-4
OFF-LINE MODE
Printing
Test
Menu
Printin
g
Menu
Setu
p
Debug/Test Info
In
q
uirin
g
Select Current Macro
Select User to Setup
Configure
IBM Configure
LQ Configure
Save Parameters
User’s Guide
A
SCII Character Set
Character Attributes
Dr. Grauert
Photo Sensor Value
Left Margin
Top Margin
Run In Test
Bidirectional Aligment
Print Photo Values
Inquire Photo Values
Resume Hardware
Parameters
Data Backup Mode
Printing Saved Data
Printing Last Data
Printing Flash Data
Directly Dump
FW Version
HW Version
Printer ID
Level 1
Level 2