Filter
Top Products
ACCULINK 336x E1 NTU
C-22 December 1996 3360-A2-GB20-20
Table C-10
(2 of 2)
SNMP Trap Configuration Options
Entp Trap: Enab
Next Enab Disab Prev
Enterprise Specific Traps. Specifies whether enterpriseSpecific traps are enabled. For more information, refer to the
SNMP Traps
section in Chapter 4,
Maintenance
.
Enab – Sends trap messages for enterpriseSpecific events to the currently configured trap manager(s).
Disab – Disables the sending of trap messages for enterpriseSpecific events.
NOTE: This configuration option is not available if the SNMP Trap configuration option (in the
Alarm Configuration
Options
section) is disabled.
Link Trap: Both
Next Disab Up Down Both Prev
Link Trap Type. Specifies the link trap type to enable. Interfaces monitored for linkUp and linkDown traps are specified
with the Trap I/F configuration option. For more information, refer to the
SNMP Traps
section in Chapter 4,
Maintenance
.
Disab – Disables the sending of trap messages for linkDown or linkUp events.
Up – Sends trap messages for linkUp events to the currently configured trap manager(s).
Down – Sends trap messages for linkDown events to the currently configured trap manager(s).
Both – Sends trap messages for linkUp and linkDown events to the currently configured trap manager(s).
NOTE: This configuration option is not available if the SNMP Trap configuration option (in the
Alarm Configuration
Options
section) is disabled.
Trap I/F: All
Next NET DTE E1s Ports All Prev
Link Trap Interfaces. Specifies which interfaces generate linkUp and linkDown trap messages. These traps are supported
on the E1 interfaces (network and G.703 DTE) and the synchronous data ports.
NET – Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the
network interface.
DTE – Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the
G.703 DTE interface. This selection is not displayed if the G.703 DTE interface is disabled.
E1s – Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on either
the network or G.703 DTE interface.
Ports – Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the
synchronous data ports.
All – Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the
network interface, G.703 DTE interface, or the synchronous data ports.
NOTE: This configuration option is not available if the Link Trap configuration option is not configured to generate trap
messages for linkUp or linkDown events.