3 – Event Messages
Alarm Events
59060-05 A 3-23
A
(A1005.0039) (Fabric Login (FLOGI) from address FC_address failed)
Meaning: The payload of the FLOGI was not valid.
Action: Check the device connection or replace the device. If the problem
persists, contact your authorized maintenance provider.
(A1005.003A) (Fabric Login (FLOGI) from address FC_address failed
authorization/authentication)
Meaning: Security authentication failed.
Action: Check the security configuration on both the device and the switch
to ensure that they are configured properly.
(A1005.003B) (Warning - Debug logging filter level is set)
Meaning: Debug logging has been set using the Set Log Level command.
Action: Confirm that you intended to do this. If not, use the Set Log Level
command to change the severity level to Info, Warn, or Critical.
(A1005.003C) (User Port(s) port_numbers, isolated, lost steering path, administering them
to state DOWNED.)
Meaning: The ports required for steering the user ports have failed.
Action: Contact your authorized maintenance provider.
(A1005.003E) (Warning, port(s) port_numbers configured ONLINE, but remain DOWN after
NDCLA.)
Meaning: Ports that were down before a non-disruptive code load and
activation remain down. This message serves as a reminder
because the alarm log is cleared during the non-disruptive code
load and activation.
Action: None
(A1005.003F) (Badly formatted SML Notification Ack session session_ID string - string)
Meaning: The switch sent a notification that was not formatted correctly;
there may be a resource problem on the switch.
Action: If this is a recurring message, contact your authorized maintenance
provider.
(A1005.0040) (Unsupported SFP within port.)
Meaning: An unsupported SFP transceiver was installed in the port.
Action: Replace the transceiver.
(A1005.0041) (Setting port admin state DOWN due to POST failure)
Meaning: The port failed the power-on self test and has been disabled.
Action: Contact your authorized maintenance provider.