Filter
Top Products
3 – Event Messages
Alarm Events
3-38 59060-05 A
S
(A1007.002B) (Security: Chap session Negotiate Authentication failed)
Meaning: The local switch received an authentication negotiate frame which
failed processing. Either the payload of the frame did not match the
standard layout of the frame or the Challenge Handshake
Authentication Protocol (CHAP) session between the devices
being authenticated was not in the state where the negotiate frame
was expected.
Action: Check the remote device for a possible error condition. Reset the
port to retry again. If errors continue, disable Challenge Handshake
Authentication Protocol (CHAP) for this device if it belongs in the
fabric.
(A1007.002C) (Security: Authentication protocol msg (AUTH_DONE) inconsistent with
Authentication protocol in progress)
Meaning: The local switch received an AUTH_DONE command
authentication frame while the Challenge Handshake
Authentication Protocol (CHAP) session was not in the correct
state to expect this type of frame. The remote device is not
following standard authentication protocol.
Action: Check the remote device for a possible error condition. Reset the
port to retry again. If errors continue, disable CHAP for this device
if the device belongs in the fabric.
(A1007.002D) (Ignoring RADIUS Server RADIUS_server, invalid UDP port configured)
Meaning: A Remote Authentication Dial In Service (RADIUS) server was
configured with invalid data for the User Datagram Protocol (UDP)
port. This configuration field is required to use the RADIUS server.
Action: Set the UDP port value in the switch RADIUS server configuration
using the Set Setup Radius command.
(A1007.002E) (Ignoring RADIUS Server RADIUS_server, zero timeout configured)
Meaning: A Remote Authentication Dial In Service (RADIUS) server was
configured with invalid data for the timeout value. A valid time out
value is required to use the RADIUS server.
Action: Set the timeout value in the switch RADIUS server configuration.
using the Set Setup Radius command.
(A1007.002F) (Ignoring RADIUS Server RADIUS_server, no shared secret is configured)
Meaning: A Remote Authentication Dial In Service (RADIUS) server was
configured with invalid data for the shared secret. A valid time out
value is required to use the RADIUS server.
Action: Set the shared secret in the switch RADIUS server configuration.
using the Set Setup Radius command.