Q-Logic FIRMWARE VERSION 7.4 Switch User Manual


 
3 – Event Messages
Alarm Events
59060-05 A 3-45
A
(A3014.0003) (IOn) (Blade blade_ID set Down due to the configured blade type not
matching the installed blade)
Meaning: The I/O blade given by blade_ID has isolated because the
operational blade type does not match the configured blade type.
Action: Change the configured blade type to match the I/O blade that is
present, or insert an I/O blade of the configured blade type.
(A4000.0001) (threshold of value hit rising trigger trigger_number in value second window on
port port_number - ALARM SET
Meaning: The switch exceeded the specified threshold for the rising trigger in
the specified sample window.
Action: Investigate the specified port for problems or adjust the rising
trigger or sample window.
(A6000.0002) (Configured port speed for port port_number not compatible with media.)
Meaning: The transceiver in the named port is not capable of transmitting at
the configured port speed.
Action: Reconfigure the port speed or replace the transceiver.
(A6001.0001) (cmon: insufficient memory)
Meaning: The Hotreset command has failed due to insufficient memory on
the switch. The switch has been returned to its state before the
Hotreset command was entered.
Action: If acceptable, enter the Reset Switch command to reboot the
switch. Contact technical support if a non-disruptive code load and
activation is required.
(A6001.0002) (cmon: blade failed NDCLA)
Meaning: The Non-Disruptive Code Load and Activation (NDCLA) has failed
on this I/O blade.
Action: None
(A6001.0003) (cmon: switch failed NDCLA)
Meaning: The Non-Disruptive Code Load and Activation (NDCLA) has failed.
The switch has performed a hard reset.
Action: None
(A6001.0004) (cmon: Blade was removed during NDCLA)
Meaning: An I/O blade was removed during the Non-Disruptive Code Load
and Activation (NDCLA).
Action: None