Q-Logic FIRMWARE VERSION 7.4 Switch User Manual


 
3 – Event Messages
Alarm Events
59060-05 A 3-33
A
(A1007.0008) (Security: ESA Response failure, failing security checks)
Meaning: A failure was received during processing of the ESA received
frame. Either the payload did not match the standard layout or the
payload status indicated a reject.
Action: Check for errors on the remote side of the link. Check the
transceiver and cable. Update firmware on the remote switch.
(A1007.0009) (Security checks EFMD response failure, failing security check.)
Meaning: A remote switch rejected a Exchange Fabric Membership Data
(EFMD) frame. The port will be isolated.
Action: Check remote switch for the reason that the EFMD frame was
rejected. It is possible that the FabricBindingEnabled parameter is
different on the two switches.
(A1007.000A) (Security: Dropping lock held by domain domain_id for number seconds)
Meaning: A remote switch has held the fabric lock for too long. The local
switch is dropping the lock in order to send out a Exchange Fabric
Membership Data (EFMD) frame.
Action: None
(A1007.000B) (Security: EFMD Rejected, bad revision)
Meaning: The remote switch is running at a different Exchange Fabric
Membership Data (EFMD) version level than the local switch. Ports
will isolate.
Action: None
(A1007.000C) (Security policy restrict mode, security db differs)
Meaning: The current security policy calls for Restrict Mode, which means
that all switches in the fabric must have the same security
databases or the inter-switch links will not log in. In this case, the
security databases differ.
Action: Reconfigure the active security set so that the ISL group members
are the same.
(A1007.000D) (Security policy in mode mode, other switch in mode mode, sec db conflict)
Meaning: The security policy on the local switch differs from that of the
remote switch.
Action: Configure the security policy on the remote switch to match that of
the local switch.