Filter
Top Products
3 – Event Messages
Alarm Events
3-44 59060-05 A
S
(A3005.0001-000C) (Blade fault (valueV_HIGH - The [value]V voltage supply is out of range,
it is too high)
Meaning: A high voltage blade fault has occurred on a SANbox 9000 switch.
Action: Contact your authorized maintenance provider.
(A3006.0001-000C) (value voltage sensor shows valueV - ALARM SET)
Meaning: An out-of-range voltage condition has occurred on a SANbox 5000
switch.
Action: Contact your authorized maintenance provider.
(A3006.0001-000C) (Blade fault (valueV_LOW - The valueV voltage supply is out of range, it
is too low)
Meaning: A low voltage blade fault has occurred on a SANbox 9000 switch.
Action: Contact your authorized maintenance provider.
(A3007.0001-000C) (value voltage sensor shows valueV - ALARM CLEAR)
Meaning: The out-of-range voltage condition on a SANbox 5000 series
switch has cleared.
Action: None
(A3007.0001-000C) (Blade fault (blade_fault - CLEARED)
Meaning: The high or low voltage SANbox 9000 blade fault has cleared.
Action: None
(A3008.0000) (The configuration area was damaged or a Remake Filesystem was
performed from PROM mode. You must perform a 'config restore' to clear
this error.)
Meaning: The configuration area was damaged or a Remake Filesystem was
performed from Maintenance mode.
Action: Enter the Config Restore command to clear the error. If this does
not correct the problem, contact your authorized maintenance
provider.
(A3014.0001) (Blade in slot slot_number set Down due to failure of all AuxPorts)
Meaning: The blade in the named slot has isolated because all auxiliary ports
to the cross-connect blades have failed.
Action: Contact your authorized maintenance provider.
(A3014.0002) (Blade in slot slot_number set Online due to internal failure recovery)
Meaning: The blade in the named slot has recovered at least one auxiliary
port to a cross-connect blade and is no longer isolated.
Action: None