Q-Logic FIRMWARE VERSION 7.4 Switch User Manual


 
3 – Event Messages
Alarm Events
59060-05 A 3-35
A
(A1007.0013) (Response from address FC_address, lacks authentication, discarding)
Meaning: A response received on the indicated port lacked Common
Transport (CT) authentication.
Action: Verify that the CT security configuration of the management
application using the remote port is compatible with the
configuration of the Management Server security group on the
switch.
(A1007.0014) (Response from WorldWide Name (WWN) device_WWN address FC_address,
failed authentication, discarding)
Meaning: A request received on the indicated port failed Common Transport
(CT) authentication.
Action: Verify that the CT security configuration of the management
application using the remote port is compatible with the
configuration of the Management Server security group on the
switch.
(A1007.001C) (Security: Bad Authentication Flags)
Meaning: The received AUTH frame did not meet the standard format for the
frame payload. Within the header portion of the payload, there are
some flags that are supposed to be set to zero (0). This frame has
the flags set to something other than zero (0).
Action: Check the remote device for a possible error condition. Reset the
port to retry again. If errors continue, disable Challenge Handshake
Authentication Protocol (CHAP) for this device if it belongs in the
fabric.
(A1007.001D) (Ignoring RADIUS Server Radius_Server, invalid IP address configured)
Meaning: A Remote Authentication Dial In Service (RADIUS) server could
not be found at the configured IP address.
Action: Check the RADIUS server, or change the configuration to use an
IP address for a valid RADIUS server.
(A1007.001F) (Access reject from RADIUS server IP_address:port for device on this port)
Meaning: Security authentication has reached the maximum retry count. The
port will now isolate.
Action: Check the security configuration.