Q-Logic FIRMWARE VERSION 7.4 Switch User Manual


 
3 – Event Messages
Critical Events
3-48 59060-05 A
S
(C) (8300.0018) (ZoneSet zone_set has been activated by user user_name)
Meaning: A zone set in the zoning database has been activated
(C) (8300.0019)(ZoneSet zone_set has been deactivated by user user_name)
Meaning: A zone set in the zoning database has been deactivated.
(C) (8300.001A) (A ZoneSet activation has failed.)
Meaning: An attempt to activate a zone set has failed.
(C) (8400.0002) (Switch) (The switch is being reset - please wait)
Meaning: The switch is being reset.
(C) (8400.0003) (Switch) (The switch is being shutdown - please wait)
Meaning: The switch is being gracefully shutdown.
(C) (8400.0004) (Switch) (The switch is proceeding with a hotreset)
Meaning: Hot reset is in progress.
(C) (8400.0005) (Switch) (The switch is now performing a hotreset)
Meaning: Hot reset is in progress.
(C) (8400.0006) (Switch) (Admin mode for user user_name was canceled by user
user_name)
Meaning: Admin authority mode was canceled by another user interface
session that had the authority to do so.
(C) (8400.0008) (Switch) (The switch will be reset in several seconds
Meaning: The switch is being reset as a result of a command from a user
interface.
(C) (8400.0009) (Switch) (The switch will hardreset in several seconds)
Meaning: A hard reset of the switch is pending.
(C) (8400.000A) (Switch) (The switch will hotreset in several seconds)
Meaning: A hot reset is pending.
(C) (8400.000B) (Switch) (The switch will be shutdown several seconds)
Meaning: The switch will be shut down in several seconds.
(C) (8400.000C) (Switch) (Configuration is being restored - this could take several minutes)
Meaning: When a complete configuration restore is done on a switch, a
switch reset follows immediately to place the new configuration in
effect.