Filter
Top Products
C – Messages
Faceplate Display
C-10 59022-08 Rev. B
D
C.6
Faceplate Display
Table C-6. Faceplate Display Messages
Message User Action
Failed to clear the trap log. Verify that the user has permissions to
modify the configuration on the switch, that
the switch is reachable in the fabric, and
that the fabric is reachable from the user’s
workstation, then retry the configuration
change.
Necessary information is missing for this
switch. Firmware version on this switch is
unsupported.
The user has attempted an action which
cannot be completed because it requires
information from the switch which the
switch does not support. Update the
firmware on the switch to the latest
version.
Necessary information is missing for this
switch. Retry later.
The user has attempted an action which
cannot be completed until specific
information has been retrieved from the
switch. This condition usually corrects
within several seconds.
If the condition doesn’t correct itself, verify
that the switch is reachable in the fabric,
and that the fabric is reachable from the
user’s workstation. When the switch is
reachable again, then wait for the
application to retrieve complete
information from the switch (this may take
up to one minute), or refresh the display.
One of the selected ports is currently in
use as a donor port to allow for extended
credits on another port. Modifications to
donor ports are not permitted.
Unselect the donor ports, and then retry
the operation.
Port reset failed
Or
Request to reset to factory defaults has
failed.
Or
Request for switch reset failed
Verify that the user has permissions to
modify the configuration on the switch, that
the switch is reachable in the fabric, and
that the fabric is reachable from the user’s
workstation, then retry the configuration
change.