Filter
Top Products
2 – Using SANbox Manager
Starting SANbox Manager
2-10 59022-08 Rev. B
D
2.5
Starting SANbox Manager
To start the SANbox Manager application for the first time, choose one of the
following methods:
For a Windows platform, double-click the SANbox Manager shortcut, or
select SANbox Manager from Start menu, depending on how you installed
the SANbox Manager application. From a command line, you can enter the
SANbox_Manager command:
<install_directory>SANbox_Manager.exe
For a Linux platform, enter the SANbox_Manager command:
<install_directory>SANbox_Manager
For a Solaris platform, enter the SANbox_Manager command:
<install_directory>SANbox_Manager
The application opens with the Initial Start dialog shown in Figure 2-5. If you prefer
not to see this dialog, check the Don’t show this dialog again box. This has the
same effect as disabling the Display Initial Startup Dialog preference. Refer to
”Setting SANbox Manager Preferences” on page 2-14 for information about
setting preferences.
Figure 2-5. Initial Startup Dialog
Click the Open Configuration Wizard radio button to open the Config
Wizard to configure a switch, add a new switch, replace/restore a switch, or
recover or edit an IP configuration of an existing switch.
Click the Open Existing Fabric radio button to open the Add a New Fabric
dialog, which prompts you for a fabric name, IP address, account name, and
password. Refer to ”Adding a Fabric” on page 3-3.