Filter
Top Products
103
3. Troubleshooting
If Your Machine Does Not Operate As You
Want
Error Messages
Machine's Condition Problem/Cause Action
Please wait. Displayed when the main
power is turned on, when the
paper type (plain paper/
translucent paper (vellum)/
film) is changed, the toner is
replaced, or other situations
when the machine is getting
ready.
Wait for the machine to warm-
up.
Note
❒ When the message "Ready
to Copy" is displayed, you
can make the settings for
your copies and scan your
originals. After the origi-
nals have been scanned,
the machine will automati-
cally start copying after it
has warmed-up. See P.130
“Feed Start Trigger”
Cannot detect original size. Improper original is set. Select paper roll manually,
not in Auto Paper Select.
Change the orientation of the
originals and try scanning it
again.
In User Auto Reduce/En-
large, the original is set to L
For User Auto Reduce/En-
large, set the original to K
In User Auto Reduce/Enlarge
the original is set to K
For User Auto Reduce/En-
large set the original toL
Memory is full. The machine's memory is full
because the number of origi-
nals scanned or for perform-
ing a function. The number of
originals that can be stored in
memory depends on the size
of the originals and the func-
tion settings.
• When the Sort function is
selected, press the
[
Finish
]
key to copy the scanned
originals, and then copy
the remaining originals.
• When the Job Preset func-
tion is selected, check the
number of preset jobs, and
then try scanning the orig-
inals again.
When using the Repeat Copy
with the scanning A0(E) size
original.
Clear the Repeat Copy func-
tion.